Checking 351ve

  • 3 Replies
  • 134 Views
*

Offline Jbob

  • Member
  • **
  • 5
Checking 351ve
« on: August 24, 2017, 07:47:40 PM »
I need to figure out how to check and see if my actuators good, I had a short!
Like to ohm it out or hook power to it to see if it's ok before I hook it back up to my fleece controller?
My wires r
Green
Yellow
Green with white stripe
Red
What's best way to check?
And I would like to run your controler after I get it lined out, is the controler and LCD screen incased now or just controler!
I would like the cool LCD screen if there's a way to mount it to the top of the dash?

*

Offline hakcenter

  • developer
  • Hero Member
  • *****
  • 623
    • 1998 12v Ram
Re: Checking 351ve
« Reply #1 on: August 24, 2017, 08:07:53 PM »
No LCD screen, no need, you can bluetooth in with your android phone :)

You can apply 12v power to the power pins, I'll have to go out and verify, I really should update the wiki with the info, now that I have the 300VG connector and it's wiring is different.

*

Offline Jbob

  • Member
  • **
  • 5
Re: Checking 351ve
« Reply #2 on: August 30, 2017, 09:45:02 PM »
So it has two power wires one to open fully and one to close?

*

Offline Rx7man

  • Crazy guy
  • Hero Member
  • *****
  • 908
  • Jack of all trades
    • '94 Dodge dually
Re: Checking 351ve
« Reply #3 on: August 31, 2017, 02:23:05 PM »
I think it would be ground, 12V, CanH, and CanL
'94 dodge, Colt Cam, head worked, NV5600, 3.55's, SB clutch, Ford manual hubs w. hawk brakes, custom flatdeck, custom aluminum bumper, cab off restoration, totally new engine, Mahle pistons @19:1..HE351VE with 67mm turbine and 67x95mm compressor
440hp/1000 ft lb @ 2400 RPM