Author Topic: GT4082KLVN  (Read 133 times)

Offline raffshore

  • Member
  • **
  • Posts: 1
    • cummins ram
on: March 07, 2019, 11:50:43 AM
Hi,

I have a garret GT4082klnv, would this controller work?

Thanks

raf



Offline Rx7man

  • Crazy guy
  • Hero Member
  • *****
  • Posts: 1050
  • Jack of all trades
    • '94 Dodge dually
Reply #1 on: March 08, 2019, 02:56:39 PM
If it takes commands over CAN bus it should, though the code might have to be modified

'94 dodge, Colt Cam, head worked, NV5600, 3.55's, SB clutch, Ford manual hubs w. hawk brakes, custom flatdeck, custom aluminum bumper, cab off restoration, totally new engine, Mahle pistons @19:1..HE351VE with 67mm turbine and 67x95mm compressor
440hp/1000 ft lb @ 2400 RPM


Offline hakcenter

  • developer
  • Hero Member
  • *****
  • Posts: 751
    • 1998 12v Ram
Reply #2 on: March 08, 2019, 04:04:30 PM
The above is all there really is to say. The LBB isn't setup to do PMW output, except some basic 0-5v, but without a load. If you wanted to design a sister board with some mosfets to drive stuff..  I guess.

If it's canbus, certainly, as long as you know the listening and transmitting addresses.

AMP 2 Corinthians 8:21
For we take thought beforehand and aim to be honest and absolutely above suspicion, not only in the sight of the Lord but also in the sight of men.