Author Topic: Stand alone general setup?  (Read 2484 times)

Offline Linhster

  • Member
  • **
  • Posts: 1
  • Newbie to VGT
    • 99 Tahoe 2dr 6.2D
on: August 05, 2019, 07:48:52 AM
Is there a general diagram for for the stand alone unit that show the input needed? Building a IDI 6.2 Detroit Diesel that has throttle position sensor and engine speed sensor... What other sensor will be needed?  Eg... Atmosphere pressure, manifold pressure,  ??? Can it be connected to the CAN bus to read complete live data? 
Thanks



Offline hakcenter

  • developer
  • Hero Member
  • *****
  • Posts: 759
    • 1998 12v Ram
Reply #1 on: August 14, 2019, 07:06:26 AM
The standalone doesn't need any other additional sensors unless you want to use them as extra inputs. However you will need to code them in as per how you want them to be used.

But yes it can read all can bus data, however again you'll need to figure out all your can bussing.

AMP 2 Corinthians 8:21
For we take thought beforehand and aim to be honest and absolutely above suspicion, not only in the sight of the Lord but also in the sight of men.