Etching boards

  • 0 Replies
  • 257 Views
*

Offline Rx7man

  • Crazy guy
  • Hero Member
  • *****
  • 908
  • Jack of all trades
    • '94 Dodge dually
Etching boards
« on: April 29, 2015, 04:54:35 PM »
OK, so I know there's places that'll take your eagle schematic and etch/drill/print/assemble it for you, but if you're really working on a beta version of something, what's the best way of going about printing a board?

My buddy has a plotter that can cut vinyl, I was wondering if that would work well as an etch mask... I think it would work better than the sharpie marker I got in my Radio Shack kit.. Of course you still have to drill all the holes and everything after... double sided board is available too, it would just take a bit of additional skill to get everything to line up right on both sides
'94 dodge, Colt Cam, head worked, NV5600, 3.55's, SB clutch, Ford manual hubs w. hawk brakes, custom flatdeck, custom aluminum bumper, cab off restoration, totally new engine, Mahle pistons @19:1..HE351VE with 67mm turbine and 67x95mm compressor
440hp/1000 ft lb @ 2400 RPM