Hakcenter

[Bubby]

Is hakcenter still active?

If so does this seem right? It's been a few years, I've changed jobs and everything, and now I'm ready to get my brand new Cummins running.


He300vgt

Pinout and where to solder/install to.

Part one vgt actuator
——————————————————
Vgt actuator connector 4wires

Left to right rear of connector with locking clip, up

1-2-3-4

This wiring is to main plug harness and to relays for the main plug.


Pin-1) +5V pin 15, main harness to a relay to connect battery main power to fused power for 10A draw actuator.

Pin-2) can low pin 1 on main harness plug

Pin-3) can HI pin 9 on main harness

Pin-4) Ground, I'll run a battery/solid ground.
——————————————————
Part 2 VR sensor

VR sensor left to right clip up rear of connector

1-2-3

Pin-1) vr + pin 4 on main harness

Pin-2) ground pin 6 on main harness from lil black box spare ground.

Pin-3) VR - (negative) pin 5 on main harness

——————————————————
Part 3- the power and ground for the lil black box


Lil black box stand alone wiring from wiki, which is back of plug, clip up.

1—2– 3 - 4 - 5 - 6 - 7 - 8
9-10-11-12-13-14-15-16

To make it run wiring

Pin-8) power in fused 12v relay from key

Pin -16) ground from a solid source


——————————————————
Wiring for turbo brake


Turbo brake
Pin -10) pin 10 on main harness to toggle switched ground.




——————————————————
All wiring pins are looking at the rear of the connector, where the wires go into the connector not the use side, and the clip is always up

This should make everything work, I assume I have to power and have it reset the actuator before I install it on the turbo.

Fin~

[hakcenter]

The pins are from looking at the rear of the connector. The board should also have it labeled just to be clear.

I know I know, the actual connector has pin numbers but it's too late at this point I don't want to confuse anyone.

DO NOT POWER THE TURBO FROM THE CONTROLLER


The 12V power needs to come from a relay, preferably a 15amp fused key on relay.

I wouldn't share grounds with the controller unless you are having communications issues, typically frame ground is good enough for both.

[Bubby]

So the vr connector and all that looks right?

[hakcenter]

You can use the 5v out for your relay, everything else looks fine.